The door sections can be locked in place to prevent access and vertical track and rollers could be covered with studs/drywall. The simplest solution for a conversion that would readily (& inexpensively) be convertible back to a garage would be to install a sectional overhead door with vertical track and to store the additional hardware in the attic or purchase the other goodies when you want it to be a functional garage again. It's been 2 years, and I don't really remember what every part look like. However, I don't see any stores online selling the box with the mechanism that pushes upward to unlock the latch. Thus, the box and the latch have to be working together in order to have the door lock to work. Once the key is turned from outside, you can see the mechanism in the box pushing upwards to unlock the latch. The bars are out of the holes, so the door can be opened.įrom inside, the box that's directly the opposite of the cylinder key hole from outside houses the mechanism connecting to the latch. When the latch is turned, the spring mechanism makes the two bars go towards the center and overlap each other. When it's locked, the two bars extend through holes of metal on both sides where the door contacts. Then, you have to turn the latch that controls the long horizontal bars on both sides inside the garage door. From outside, you have to insert the key and turn, which unlocks the latch. Not far from and above it is the slender latch. From the street, you see the cylinder key hole thing. This house was built in 1995, which is not too old. I tried searching online to see if I could find the exact parts, yet I have not had luck. I found the lock missing right after the tenant moved out.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |